Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP SLA jitter output

Hi,

I've a setup with two 2800's on two datacenter and I want to see the jitter from one datacenter to the other. So I've configured an IP SLA and an responder but the output I get gives me only RTT and no jitter measurements. I've checked CCO and they say you get '0' when the devices are not timesynced. But I am sure they are in sync with each other.

Here is my config:

ip sla monitor 1

type jitter dest-ipaddr x.x.x.x dest-port 5000

request-data-size 64

tos 5

ip sla monitor schedule 1 life forever start-time now

on the other router:

ip sla monitor responder

ip sla monitor responder type udpEcho port 5000

Any ideas?

Gr,

Peter

1 REPLY
New Member

Re: IP SLA jitter output

Here is the output:

R2#sh ip sla moni stat 1

Round trip time (RTT) Index 1

Latest RTT: 2 ms

Latest operation start time: 22:16:22.747 GMT+1 Tue May 5 2009

Latest operation return code: OK

RTT Values

Number Of RTT: 10

RTT Min/Avg/Max: 2/2/2 ms

Latency one-way time milliseconds

Number of one-way Samples: 0

Source to Destination one way Min/Avg/Max: 0/0/0 ms

Destination to Source one way Min/Avg/Max: 0/0/0 ms

Jitter time milliseconds

Number of SD Jitter Samples: 0

Number of DS Jitter Samples: 0

Source to Destination Jitter Min/Avg/Max: 0/0/0 ms

Destination to Source Jitter Min/Avg/Max: 0/0/0 ms

Packet Loss Values

Loss Source to Destination: 0 Loss Destination to Source: 0

Out Of Sequence: 0 Tail Drop: 10 Packet Late Arrival: 0

Voice Score Values

Calculated Planning Impairment Factor (ICPIF): 0

Mean Opinion Score (MOS): 0

Number of successes: 16

Number of failures: 0

Operation time to live: Forever

131
Views
0
Helpful
1
Replies