I have edited the SNMP write community string now only 1 switch is not enabled,when i click on number 1 it takes me to new page of devices where i can't understand which is the one not enabled,How can i see that??
And what will the possible reason for the 1 switch which is not enabled.
The version code for those 2 switches is Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SXH1 and
Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M),Version 12.2(33)SXH.They both are with same hardware 6509-NEB-A
What page does it take you to? You can try deleting both switches from IPM, then resync them to see if they come back as enabled. Provided the SNMP community strings are correct, there is nothing else you would need to do to enable IP SLA on these devices.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...