Mar 5 10:27:06.976: %RTT-3-IPSLATHRESHOLD: IP SLAs(3): Threshold below for rtt
Mar 5 10:27:06.980: %RTT-3-IPSLATHRESHOLD: IP SLAs(3): Threshold below for rtt
And therefore, causing EEM to act twice ..which is a memory/cpu waste.
Mar 5 10:26:47.516: %SYS-5-CONFIG_I: Configured from console by vty1
Mar 5 10:26:47.620: %SYS-5-CONFIG_I: Configured from console by vty2
Using average or immediate works just fine.
One more thing ..i'm not sure if I understood 'average' , does it mean that if you have it configured for 5 attempts , you for example get a failure today, and the other day another 4 failures then it will trigger?
Here is my IOS:
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 15.0(1)M
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...