cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
415
Views
0
Helpful
2
Replies

IPM 2.6 and 6524

Hi,

I noticed a strange behavior when I set a collector with 6524 as a source.

In fact, after I initialize the collector, the router suddenly restarts.

I've IPM v2.6 and 6524 with 12.2(18)ZU2 rsw release.

Anyone could help me to understand this behaviour?

Thanks

antonio

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

I'm not certain IP SLA is supported on the ME 6500 series devices yet. In any event, it certainly should not crash when you try to use it. I suggest you open a TAC service request with the show tech from this switch. The "show stack" output can be analyzed to see where the crash occurred.

yjdabear
VIP Alumni
VIP Alumni

Sounds similar to CSCin62031 impacting up to 12.2(18)SXF4, but 12.2(18)ZU2 is not listed.

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCin62031&from=summary

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco