IPM action configuration

[MathieuJM_2]

Hi all,

I have configured the IPM to test an IP address on port 8080 and to send a SNMP trap when a threshold is rised.

But i can't find where i should define the SNMP trap receiver in the application. Is it only the DFM that can receive the trap or can i define another SNMP trap collector ?

Regards

[akemp]

SNMP Trap recipients are a device level configuration so IPM doesnt touch them. You have to use netconfig or something else to define where you want all of your SNMP traps to be sent.

[MathieuJM_2]

Thank you, so i will just configure the SNMP host in my source device to enable my event to send a trap.