08-05-2009 12:53 AM
hi,
how to configure IPM for icmp jitters.
can i configure the same for my lan devices and critcal links.
Solved! Go to Solution.
08-05-2009 04:18 AM
You have to configure source and target device (must have responder functionality enabled). Then you configure type of monitor and time frame (by time frame I mean if it is Real-time, or historical). Just follow the steps.
Then you wait a bit and results should show in IPM tab.
08-05-2009 03:56 AM
Hi!
You have to enable responder functionality on devices you are trying to monitor.
08-05-2009 04:05 AM
how to enable that. pl help.
will it enable on enabling the snmp traps.
08-05-2009 04:10 AM
conf term
ip sla responder
Which devices are you talking about?
08-05-2009 04:13 AM
cisco devices only. any other things that need to be configured.
08-05-2009 04:18 AM
You have to configure source and target device (must have responder functionality enabled). Then you configure type of monitor and time frame (by time frame I mean if it is Real-time, or historical). Just follow the steps.
Then you wait a bit and results should show in IPM tab.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide