Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

IPM and ICMP Jitter

hi,

how to configure IPM for icmp jitters.

can i configure the same for my lan devices and critcal links.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: IPM and ICMP Jitter

You have to configure source and target device (must have responder functionality enabled). Then you configure type of monitor and time frame (by time frame I mean if it is Real-time, or historical). Just follow the steps.

Then you wait a bit and results should show in IPM tab.

5 REPLIES
New Member

Re: IPM and ICMP Jitter

Hi!

You have to enable responder functionality on devices you are trying to monitor.

Re: IPM and ICMP Jitter

how to enable that. pl help.

will it enable on enabling the snmp traps.

New Member

Re: IPM and ICMP Jitter

conf term

ip sla responder

Which devices are you talking about?

Re: IPM and ICMP Jitter

cisco devices only. any other things that need to be configured.

New Member

Re: IPM and ICMP Jitter

You have to configure source and target device (must have responder functionality enabled). Then you configure type of monitor and time frame (by time frame I mean if it is Real-time, or historical). Just follow the steps.

Then you wait a bit and results should show in IPM tab.

212
Views
0
Helpful
5
Replies