Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IPM Collector - Scheduled Status -

I'm running LMS 3.2 w/ IPM 4.2.0 (10k license). I have been attempting to create various collectors, with some being fully successful, while others remain in a status of scheduled. They have been in this status for >24 hours. Any thoughts?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: IPM Collector - Scheduled Status -

Not unless the collector was scheduled to run in the future.  That's what the scheduled state typically means.

4 REPLIES
Cisco Employee

Re: IPM Collector - Scheduled Status -

There might have been a problem configuring them on the source device in question.  Alternatively, it may have been that they were schedule to run in the distant future.  Delete one of these collectors, and try recreating it filtering on all SNMP traffic between the IPM server and the device.  Post the capture file.

New Member

Re: IPM Collector - Scheduled Status -

Thanks for the response Joe.

Interestingly, after 48 hours or so, all of the collectors that stated they were in the scheduling state finally configured themselves. Have you ever seen that before?

Cisco Employee

Re: IPM Collector - Scheduled Status -

Not unless the collector was scheduled to run in the future.  That's what the scheduled state typically means.

New Member

Re: IPM Collector - Scheduled Status -

It was scheduled to run immediately. Oh well, if it happens again, I'll run through the troubleshooting steps. Thanks for your help.

166
Views
0
Helpful
4
Replies