Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPM in LMS3.0

Hi,

Is it possible to use IPM to monitor a interface in core switch for any traffic.

Or do we need a source and a destination for using IPM?

with thanks in advance

sathappan.s

4 REPLIES
Cisco Employee

Re: IPM in LMS3.0

IPM is not designed to monitor traffic or load on interfaces. It is designed to use synthetic probes (known as collectors) to gather latency and round-trip response time about paths or hops in the network. This requires an IP SLA source device, and some IP addressable target (for most operations).

We will be coming out with an add-on product to LMS in December called Health and Utilization Monitor which will allow you to monitor specific interfaces for traffic statistics.

New Member

Re: IPM in LMS3.0

Thanks Joe

Blue

Re: IPM in LMS3.0

Would Health and Utilization Monitor be a free add-on?

Cisco Employee

Re: IPM in LMS3.0

No, it will be priced and licensed separately from LMS. The eval will ship with LMS 3.0.1, however.

121
Views
3
Helpful
4
Replies