cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
751
Views
0
Helpful
2
Replies

IPM restore gets stuck at 40 % and 90%

MARVIN SPITERI
Level 1
Level 1

During a restore from 2.6 backup to a new clean 3.1 install, the process seems to halt at 40% it stayed like this for 8 hours so I had to stop with control c then it stuck again at 90% - in the end it still reported as successful

2 Replies 2

smahbub
Level 6
Level 6

can you provide the exact error message taht you are getting ehile performing the restore which will help us better to find the cause of the issue and resolve the same.

Hi thanks for replying, the strange thing is that there were no error messages it just seemd to halt at 90% it stayed that way overnight 8hrs - then with cntl c it continued - no errors noticed in logs

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: