During a restore from 2.6 backup to a new clean 3.1 install, the process seems to halt at 40% it stayed like this for 8 hours so I had to stop with control c then it stuck again at 90% - in the end it still reported as successful
Hi thanks for replying, the strange thing is that there were no error messages it just seemd to halt at 90% it stayed that way overnight 8hrs - then with cntl c it continued - no errors noticed in logs
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...