Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

IPStatus=TIMEXCEEDINTRANS

IPStatus=TIMEXCEEDINTRANS

I get unresponsive alerts from DFM where ipstatus is IPStatus=TIMEXCEEDINTRANS. Admin and oper status is UP. What causes that alert. Any idea.

thanks

juha

1 ACCEPTED SOLUTION

Accepted Solutions

Re: IPStatus=TIMEXCEEDINTRANS

usually it is that DFM cannot succesfully ping the interface and get a response like 'TTL exceeded in transmit'; Admin and Oper status are determined by snmp so there is no problem with this. DFM monitoring of IP interfaces relies on both successfull ICMP and SNMP communication. There is a script available from TAC to change this behaviour in the way that DFM does not try to ping a certain interface.

Have a look a this thread:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddefa96/0#selected_message

1 REPLY

Re: IPStatus=TIMEXCEEDINTRANS

usually it is that DFM cannot succesfully ping the interface and get a response like 'TTL exceeded in transmit'; Admin and Oper status are determined by snmp so there is no problem with this. DFM monitoring of IP interfaces relies on both successfull ICMP and SNMP communication. There is a script available from TAC to change this behaviour in the way that DFM does not try to ping a certain interface.

Have a look a this thread:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddefa96/0#selected_message

137
Views
0
Helpful
1
Replies
CreatePlease to create content