We have two cisco 3560 switch and both are configured as primary and secondary switch. Servers are connected on both switches and gateway for them are HSRP virtual ip address. Now we are implementing IPV6 on both switches. As per cisco, that v4 and v6 hsrpc on not implement on same SVI. Is it possibale to use same anycast address on both switch SVI so if primary switch goes down the same address i.e. gateway will be on secondary switch.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...