Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Is it possible?

The Detailed Device report will show modules that have a Major or Minor Fault.

Is it possible in RME or Campus (NOT USING DFM) to find ports that are in an errror disabled state?

1 ACCEPTED SOLUTION

Accepted Solutions
Red

Re: Is it possible?

It would look something like this:

00:21:04: %PM-4-ERR_DISABLE: psecure-violation error detected on Fa0/1, putting Fa0/1 in err-disable state

5 REPLIES
Red

Re: Is it possible?

If you can get the switches to send syslog messages for error disabled, then you would be able to use RME.

New Member

Re: Is it possible?

Do you have an example of the syslog message....severity and facilty?

Red

Re: Is it possible?

It would look something like this:

00:21:04: %PM-4-ERR_DISABLE: psecure-violation error detected on Fa0/1, putting Fa0/1 in err-disable state

New Member

Re: Is it possible?

Thank you.

New Member

Re: Is it possible?

Here's what I was able to do:

From RME > Configuration Mgmt > Network Show Commands > Batch Reports >, I was able to define a report for show port status, Schedule the Report and run the report.

This of course to find ports that went disabled before I got syslog setup and working on all devices.

113
Views
5
Helpful
5
Replies
CreatePlease to create content