Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

is that possible import cs user defined group to RME

is that possible import cs user defined group to RME on LMS 3.2  Thanks,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: is that possible import cs user defined group to RME

No, you can't do an import as each application maintains its own set of user-defined group attributes.

3 REPLIES
Cisco Employee

Re: is that possible import cs user defined group to RME

No, this is not possible, but RME can use the user-defined groups in CS.  They should be visible in the RME device selector.

New Member

Re: is that possible import cs user defined group to RME

thanks but my objective is since I have problem(takes 5-8 minutes)Cs user defined grups to open one group on topology services.I want to create user defined group under CM or RME on topology services because groups created under CM or RME appears to be very fast on to open topology view.and trying to avoid to creat again close to 200 groups again manually. but appears to be I don't have any other chance.Thanks.

Cisco Employee

Re: is that possible import cs user defined group to RME

No, you can't do an import as each application maintains its own set of user-defined group attributes.

181
Views
0
Helpful
3
Replies
CreatePlease login to create content