Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

issue of "Out-of-Sync"

In our company, there are lots of Cisco Catalyst Blade Switches 3030 for Dell. I always found "out-of-sync" report of these switches. When I opened different version, it is only about "ntp clock-period" change. But actually it did not belong to real change, but other switches (like 3750) were not found the similar report(Even though I could found the same "change").Is this kind of switch bug or is the issue from my settings?

Thanks for your response

1 REPLY
Cisco Employee

Re: issue of "Out-of-Sync"

These switches must be missing the list of default exclude commands. Go to RME > Admin > Config Mgmt > Exclude Commands, find this switch type, and add the following as the default list:

end,exec-timeout,length,width,certificate,ntp clock-period

266
Views
15
Helpful
1
Replies