I'm attempting to import devices into our RME 3.5 install using the CSV "Import from File" option. I've created a file as a test before doing a batch import (trying to add 115 2811 routers) and when I go to import I'm brought to the "Add/Import Status Summary." On here the device is not show under any category. I ran checkaddr.pl and RME is able to poll SNMP off the device. I'm at a loss as to how to continue. Is there a way to debug this import process? I tried a command line import but that provided no output nor did the device import. Below is my import file:
cisco Systems NM data import, source = Hand edit; Version = 1.0; Type = csv
Thanks for the recommendation. If I add the device that way I'm able to import it without issue. I get a message saying "DIServer processing ." That message never shows when doing an import from a file. Thanks for the help so far.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.