We have recently migrated from our NCS to Prime Infra 2.1.1. Since doing this we have started to import or switching gear into PI in addition to our WLC and MSE appliances. Discovery and inventory of the 3750X and 4500-X switches has been without issue. When we point PI 2.1.1 to a Nexus 7K running a VDC, the switch discovers as a Nexus 9500 instead of a 7K. Anyone else seen this happen? Any work arounds or suggestion on what might be going on? My thought was its discovering a VDC on the 7K and its not the admin VDC. That said our Admin VDC is not configured for SNMP and we wanted to discover the VDC's that we actually use for client traffic. I should note we have loaded the lastest available device pack to PI as well.
Please advise - any help would be greatly appreciated.
We ran a discovery of all our Nexus switching last night. Once we did that the patter was easy to see. Any 9 or 10 slot Nexus was fine, any 4-slot Nexus appears as a Nexus 9500 instead of a 7K. I checked the compatibility matrix (latest release through DP 6.0) and support for the 9/10/18 slot is listed. No mention of support for the 4 slot. I believe that is our issue.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...