Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

job failed in RME Netconfig

hi

I keep gettnig this error when I run a netconfig job (add commande) in a 3560 switch :

ERROR:RME_CDL1031:Transport session to device failed TFTP: Failed on the device. Unable to create a socket to /10.128.31.37

Anyone know what the cause of this error?

4 REPLIES
Cisco Employee

Re: job failed in RME Netconfig

It looks like you don't have the proper Netconfig deployment protocols selected under RME > Admin > Config Mgmt > Transport Settings. Either that, or the switch is not reachable by either telnet or SSH from the LMS server.

Community Member

Re: job failed in RME Netconfig

hi,

i verify the netconfig deployment protocols in RME and it's OK.

i configure properly the job but i have always this error:

ERROR:RME_CDL1031:Transport session to device failed TFTP: Failed on the device.

what the cause ?

Cisco Employee

Re: job failed in RME Netconfig

What is your deployment protocol order? What protocol should be used to deploy this config change?

Community Member

Re: job failed in RME Netconfig

thank you clarke, i remover "tftp" from the list of protocol used to deploy the config by netcofig. and i use only telnet, so every thing is ok.

thank you!

284
Views
0
Helpful
4
Replies
CreatePlease to create content