Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Kill Tcl process !

Hi all. I ran below script on my router for some testing purpose

foreach address {

10.1.1.1

10.1.1.2

10.1.1.3

.

.

.

10.1.1.254

} { ping $address re 2

}

As you can see this will ping the entire subnet. But after executing it, is there any way to kill this process ? any way of terminating it ?

Kindly guide me

3 REPLIES
Cisco Employee

Re: Kill Tcl process !

You can try either Control+^ then x or Control+C. Depending on the version of IOS, one of those should work.

Community Member

Re: Kill Tcl process !

Dear Sir, its not working, my IOS is 12.4(20)T. router is 2801. I tried all the combinations

ctrl + c

ctrl + z

ctrl + shift + 6

None is working. Can you tell me how to terminate it ?

Thanks in advance

Cisco Employee

Re: Kill Tcl process !

After cntrl+shift+6, did you type 'x'? If that's not working, try clearing the vty line on which the Tcl script is running.

1075
Views
0
Helpful
3
Replies
CreatePlease to create content