Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Kiwi syslog

Hello,

I have the following configured on my router but nothing display in my kiwi syslog. I'm new to this so please help. Thanks

logging buffered 4096 debugging

logging console informational

logging monitor informational

logging facility local3

logging source-interface FastEthernet0/0

logging 10.17.84.51

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Kiwi syslog

These types of events do not generate syslog messages. A config change, on the other hand, does generate a message. If you need a comprehensive list of available syslog messages, you can use the system error messages guide for your release of IOS. For example, for IOS 12.4, see http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124sup/124sms/index.htm .

If you define ACLs, and configure them for logging, you can get syslog messages for traffic that matches. However, this can be burdensome to the device if a lot of traffic is passing through it.

5 REPLIES
Red

Re: Kiwi syslog

Check on your Kiwi syslog server to make sure it is listening on local3

The default setting on Cisco devices is local7

New Member

Re: Kiwi syslog

You are right but for some reason it only logged whenever I do a changed on my router. It doesn't log anything else. Please help. Thanks

Cisco Employee

Re: Kiwi syslog

What do you want it to log? What events are occurring on your device that you think should be logged, but are not being logged?

New Member

Re: Kiwi syslog

Example like traffic going in and out of the outside interface and log anyone login to the router (currently only log when you make changes). Thanks

Cisco Employee

Re: Kiwi syslog

These types of events do not generate syslog messages. A config change, on the other hand, does generate a message. If you need a comprehensive list of available syslog messages, you can use the system error messages guide for your release of IOS. For example, for IOS 12.4, see http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124sup/124sms/index.htm .

If you define ACLs, and configure them for logging, you can get syslog messages for traffic that matches. However, this can be burdensome to the device if a lot of traffic is passing through it.

139
Views
9
Helpful
5
Replies
CreatePlease to create content