We configured netflow at a 6509E with version 12.2.
mls aging long 120 mls aging normal 60 mls netflow interface mls flow ip interface-full mls nde sender version 5 ip flow-export source vlan1 ip flow ingress layer2-switched vlan xxx-yyy ip flow-export destination 10.1.1.1 20
and we added some "ip flow ingress" at selected interfaces.
interface Vlanxx1 ...
ip flow ingress
it works as expected
Now we need to configure it at 6509E with version 15
It is ok to configure the interfaces with flow monitor and exporter, but I didn´t find the layer2 netflow command.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...