Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

license problem after restore full backup

(This software installation requires reusing a license provided in a previous version. If a previous license is not available or proof of purchase validation was not performed, you may continue to install in NAG mode, while arranging with your Cisco representative to return this product and purchase a full licensed version.)

the above message is appeared after restore full backup of LMS2.6 with CS 3.0.6 and RME 4.0.5 and when I open any page IN GUI to run the validateupgrade command, after run this command, it gave me:

((

root@sec5-12 # pwd

/opt/CSCOpx/bin

root@sec5-12 # ./validateupgrade ld.so.1: validateupgrade: fatal: libstdc++.so.3: open failed: No such file or directory Killed

))

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: license problem after restore full backup

You need to setup LD_LIBRARY_PATH before running validateupgrade:

env LD_LIBRARY_PATH=/opt/CSCOpx/MDC/lib:/opt/CSCOpx/lib /opt/CSCOpx/bin/validateupgrade

1 REPLY
Cisco Employee

Re: license problem after restore full backup

You need to setup LD_LIBRARY_PATH before running validateupgrade:

env LD_LIBRARY_PATH=/opt/CSCOpx/MDC/lib:/opt/CSCOpx/lib /opt/CSCOpx/bin/validateupgrade

108
Views
0
Helpful
1
Replies
CreatePlease to create content