Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Link state logs in syslog CiscoWorks LMS 2.6

I can see on my devices the log (via show log) the following :-

UTC: %LINK-3-UPDOWN:

However when I pull a syslog report by device or 24 hour summary I do not see these in the syslog report? Any ideas?

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: Link state logs in syslog CiscoWorks LMS 2.6

It's filtered by one of the default/out-of-the-box filters. See it at RME - Tools - Syslog - Message Filters:

Name: Link Up/Down Message Filter

Type: Message Filter

State: Enabled

Devices_Latest: *

Messages: LINK-*-3-UPDOWN:* LINEPROTO-*-5-UPDOWN:* LINK-*-5-CHANGED:* LINK-*-5-UPDOWN:*

1 REPLY
Blue

Re: Link state logs in syslog CiscoWorks LMS 2.6

It's filtered by one of the default/out-of-the-box filters. See it at RME - Tools - Syslog - Message Filters:

Name: Link Up/Down Message Filter

Type: Message Filter

State: Enabled

Devices_Latest: *

Messages: LINK-*-3-UPDOWN:* LINEPROTO-*-5-UPDOWN:* LINK-*-5-CHANGED:* LINK-*-5-UPDOWN:*

202
Views
0
Helpful
1
Replies
CreatePlease to create content