Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Link Utilization with Ciscoworks LMS 3.1

Hi all,

Is it posible to see the link utilization on a router's serial interface with LMS 3.1?

If yes, please explain.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Link Utilization with Ciscoworks LMS 3.1

Yes. You can use the Health and Utilization Monitor plug-in module to do this. HUM ships as a 90-day eval along with LMS 3.1.

To do this in HUM, you would need to create an Interface Utilization poller under HUM > Poller Management.

1 REPLY
Cisco Employee

Re: Link Utilization with Ciscoworks LMS 3.1

Yes. You can use the Health and Utilization Monitor plug-in module to do this. HUM ships as a 90-day eval along with LMS 3.1.

To do this in HUM, you would need to create an Interface Utilization poller under HUM > Poller Management.

240
Views
0
Helpful
1
Replies
CreatePlease login to create content