Hello,
We have several Linksys RVL200 routers out in the field. They work fine except now we want to enable SNMP to monitor bandwidth usage with PRTG Network Monitor. I’m having a problem with a few of these getting SNMP to work properly.
I’ve configured all the devices exactly the same, however some of them will not display the Ethernet sensors to monitor bandwidth properly.
I believe we have the latest firmware installed (v1.1.7).
I’ve done some onsite testing with an SNMP tester and the results are the same.
Do you have any suggestions on how I can proceed?
Thank you,
John
