Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Listing devices by IP addresses.

When CW does an automated acquisiton of devices on the network, I noticed that it does not list them by hostname but rather IP address and sometimes two IP addresses of the same device but different ports. How can i get CW to list devices by hostname

2 REPLIES
Cisco Employee

Re: Listing devices by IP addresses.

If you have DNS configured and the hostnames are fully resolvable you can configure CM to list the devices by hostname.

The list of device discovered will show a hostname column and also in the topo map you can select view label to display hostname.

Remember that DNS is the most important part...the hostname command on the device itself would be sysName. If hostnames are discovered CM will send these hostnames to the CS DCR.

Cisco Employee

Re: Listing devices by IP addresses.

Also, you can using resolver.pl in the CSCOpx/bin directory to test the DNS resolution. If it doesn't resolved then LMS won't get hostnames.

291
Views
0
Helpful
2
Replies