Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 1900

Hi,

I have 1900 devices not getting discovered. Only one got discovered after I added it as a seed device but it does not show the cdp neighbours in topology map.

They have CAT OS and is there any issue with catOS devices :

na100110#sh ver

Cisco Catalyst 1900/2820 Enterprise Edition Software

Version V9.00.03

Copyright (c) Cisco Systems, Inc. 1993-1999

na100110 uptime is 101day(s) 07hour(s) 18minute(s) 32second(s)

cisco Catalyst 1900 (486sxl) processor with 2048K/1024K bytes of memory

Hardware board revision is 5

Upgrade Status: No upgrade currently in progress.

Config File Status: No configuration upload/download is in progress

15 Fixed Ethernet/IEEE 802.3 interface(s)

Base Ethernet Address: 00-02-B9-4E-20-00

I have snmp configured as well.

Please advise.(LMS 3.1)

-Thanks

1 REPLY
Cisco Employee

Re: LMS 1900

It's been a while since I used a 1900 switch. You should be able to get to a CLI, then run "show cdp nei" to see its CDP neighbors. Are they showing up there?

115
Views
5
Helpful
1
Replies
CreatePlease to create content