i have the following question regarding path analysis in campus mgr:
for some reason I don't see the layer-2-path and its devices, such as access-switches
device fault manager:
i have defined email-notification and out of this notification via sms-gateway which works perfectly but we get to many mails and sms-messages (e.g.messages from the device itself, messages from the interface and so on) in case of dfm-alerts. is there a possibility to set any parameters which helps to decrease the number of notification-messages ?
any hints or tips for regarding these 2 questions are very welcome and appreciated
Path analysis: this might be because you have disabled IP redirects.
We have the same problem. CM states that the VLAN mapping table is not complete. But there are REALLY LIMITED number of mappings in this table. I found that IP redirects should be allowed in order to have path analysis to work.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...