Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 2.5 CM and D&C

Does anyone know why devices discovered by Campus Mgr via its decvice discovery tools do not end up in the Device and Credentials repository?

Thanks

5 REPLIES
Red

Re: LMS 2.5 CM and D&C

DeviceDiscovery will not send Unreachable devices to Device and Credentials

New Member

Re: LMS 2.5 CM and D&C

Why does CM set the status of the devices it discovered to "UnReachable" and is there a way to correct this?

Thanks for the reply.

Red

Re: LMS 2.5 CM and D&C

Unreachable could be incorrect SNMP configuration or timeout

New Member

Re: LMS 2.5 CM and D&C

I confirmed SNMP community string works by doing a MIB walk. Is this an old problem that there is a fix for?

Re: LMS 2.5 CM and D&C

A device can be discoverd by CDP neighbour through one of its neighbour devices but it could be that it has an access-list or snmp-view configured so that the management station cannot reach it via SNMP. Make sure SNMP communication works from the *management station* to the device: open DeviceCenter and enter the IP address of the device, down left you will get "SNMP Walk". Enter the community string and enter "system" as the OID. If the communication is ok, enter the community for the *IP* of that device in the SNMP config dialog for discovery and restart the disco.

HTH,

Martin

102
Views
0
Helpful
5
Replies