Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

LMS 2.5 netconfig and TACACS

I have LMS 2.5 working fine backing up switches but i have a query regarding restoring switches. Just say a switch is replaced, so its a blank config. If i were to attempt to restore the switch config using netconfig, would it not copy the config from the top down? What i mean is it would apply the TACACS authorisation and then not do anything else until you log in with the relavant credentials?

Any ideas on how to get around this?

Thanks

1 REPLY
Red

Re: LMS 2.5 netconfig and TACACS

A better way around this would be to use Config Editor and download the entire config in one shot.

104
Views
0
Helpful
1
Replies