cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1019
Views
15
Helpful
2
Replies

LMS 2.5 user authentication problem

joshmwoody
Level 1
Level 1

Set up Works to run in ACS mode. Created user account on ACS. Created user account on works and assigned SA and NA roles. I can log in successfully and verified access permissions from Who is logged in Report. The problem is when I try to access certain application features eg Device Management Summary in RME I get the following error

You are not authorized to request the Action associated with screenID: "/deviceSummary".

Any ideas of where to look next appreciated

1 Accepted Solution

Accepted Solutions

David Stanford
Cisco Employee
Cisco Employee

It looks like you might have missed the steps in ACS to add the LMS modules.

ON ACS

=======

* Step 7: Add "SUPERUSER" role for each module of Ciscoworks in ACS

-Go to SHARED PROFILE COMPONENTS

-Select a CW module (such as Common Services)

-ADD

-Name it CWSuperUser or something similar

-Select everything under the available functionality for that module

--REPEAT above procedure for Ciscoview, RME, Campus, DFM and any other Ciscoworks modules

such as IPM, etc.

* Step 8: Assign the "SUPERUSER" role to the Admins Group (created in Step 3)

-Go to GROUP SETUP

-Edit Settings

- Select cwhp, rme, campus, dfm and any other CW components a select the "SUPERUSER" role

(created in step 7)

-Submit+Restart

View solution in original post

2 Replies 2

David Stanford
Cisco Employee
Cisco Employee

It looks like you might have missed the steps in ACS to add the LMS modules.

ON ACS

=======

* Step 7: Add "SUPERUSER" role for each module of Ciscoworks in ACS

-Go to SHARED PROFILE COMPONENTS

-Select a CW module (such as Common Services)

-ADD

-Name it CWSuperUser or something similar

-Select everything under the available functionality for that module

--REPEAT above procedure for Ciscoview, RME, Campus, DFM and any other Ciscoworks modules

such as IPM, etc.

* Step 8: Assign the "SUPERUSER" role to the Admins Group (created in Step 3)

-Go to GROUP SETUP

-Edit Settings

- Select cwhp, rme, campus, dfm and any other CW components a select the "SUPERUSER" role

(created in step 7)

-Submit+Restart

not sure where those steps are documented, but that worked for me.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco