Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 2.6 and HP Openview 7.5

Hi,

Does anyone know it LMS 2.6 can integrate with HP Openview Network Node Manager 7.5 ? Or can i install integration utility 1.7 to LMS 2.6 server in order to communication with openview 7.5 ?

Thanks,

Regards,

Jan

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: LMS 2.6 and HP Openview 7.5

Yes, it does integrate with NNM 7.5:

If they are to be on same server, you can download and install Adapter.v1-7.sol.nnm.tar (assuming solaris) to CW box.

http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-nnm

(also download readme for directions).

Readme does mentions:

Adapter(Version 1.7) for integrating Cisco Applications and Cisco Devices into HP Network Node Manager 6.4 , 7.0 , 7.01 and 7.5 versions

If you are installing NNM on separate server, you can install the Integration Utility (IU) on the remote server where HP NNM is installed which you may download from this link:

http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-utility

Cisco Employee

Re: LMS 2.6 and HP Openview 7.5

Yes that's right, you can do this with LMS 2.6

3 REPLIES
Cisco Employee

Re: LMS 2.6 and HP Openview 7.5

Yes, it does integrate with NNM 7.5:

If they are to be on same server, you can download and install Adapter.v1-7.sol.nnm.tar (assuming solaris) to CW box.

http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-nnm

(also download readme for directions).

Readme does mentions:

Adapter(Version 1.7) for integrating Cisco Applications and Cisco Devices into HP Network Node Manager 6.4 , 7.0 , 7.01 and 7.5 versions

If you are installing NNM on separate server, you can install the Integration Utility (IU) on the remote server where HP NNM is installed which you may download from this link:

http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-utility

New Member

Re: LMS 2.6 and HP Openview 7.5

Thank you very much.

So I can just install Integration Utility 1.7 into Openview 7.5 without upgrading ciscowork to LMS 3, right ?

Regards,

Jan.

Cisco Employee

Re: LMS 2.6 and HP Openview 7.5

Yes that's right, you can do this with LMS 2.6

140
Views
5
Helpful
3
Replies