Sometimes, if i add a device to LMS 2.6, it doesnt appear in the DCR straight away, but does show in the "devices not configured in ACS" report. However the devices are in ACS, and after i stop/start dmgtd, the devices appear in the DCR.
Obviously i dont want to be stopping/starting the daemons everytime i add a device.
Any idea what is causing this or how LMS gets the information from ACS (Can this information be refreshed without restarting all daemons etc)?
For info, we are running LMS 2.6 on solaris, connecting to ACS 4.0.1.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...