Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 2.6 - DFM - Disable Alerting on Duplicate IP

I'm trying to clean up some of the false positives in DFM and have eliminated most of the ones I've seen by simply unmanaging interfaces or ports, but there is one alert that I can't seem to find a good way to get rid of. We have a few sites that have two 2811 routers at them for redundancy. These routers are configured to look exactly the same as far as interfaces and IPs go, minus a management interface and cross-connect, which of course would have to be different in order to manage the devices. For all other interfaces, the routers have the same IPs configured in a 1 to 1 mirror situation. The problem this poses, is that DFM sees these duplicate IPs and alerts on them. This is a fantastic feature, but for this situation, I would like to eliminate the duplicate IP alert for these routers only.

I've been looking at customizing notifications, but I can't seem to find where I can actually remove the alert from DFM. I've unmanaged all of the interfaces that are configured with these addresses, but it doesn't seem to make the error go away. I'm guessing it's picking these up when polling the Loopback0 interface, and then alerting on them.

Is there a way for me to remove the Duplicate IP alert for just these routers? I'm sure there is a simple answer I'm over looking, but if any of you know, I would greatly appreciate it. Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 2.6 - DFM - Disable Alerting on Duplicate IP

No, you cannot do that. The duplicate IP event is not one that is customizable.  DFM currently does not understand L3 redundancy, and thus throws these false positive duplicate errors.

3 REPLIES
Cisco Employee

Re: LMS 2.6 - DFM - Disable Alerting on Duplicate IP

No, you cannot do that. The duplicate IP event is not one that is customizable.  DFM currently does not understand L3 redundancy, and thus throws these false positive duplicate errors.

New Member

Re: LMS 2.6 - DFM - Disable Alerting on Duplicate IP

Thanks for the reply! I guess I'll just mark those alerts as acknowledged and disregard them.

Re: LMS 2.6 - DFM - Disable Alerting on Duplicate IP

What does this mean exactly ? "DFM currently does not understand L3 redundancy...."

Are they working on a change of this (mis-)behaviour?

627
Views
0
Helpful
3
Replies
CreatePlease login to create content