Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

LMS 2.6 Pulling Router Config

In LMS 2.6 how can I pull the config from a Cisco Router? I know only the Read SNMP String. Thanks for any help!

1 REPLY
Cisco Employee

Re: LMS 2.6 Pulling Router Config

If all you have is the SNMP read-only community string, you cannot get the configuration. You must have one of either the SNMP read-write community string, or the ability to login via telnet or SSH, and get enabled.

If you configure those credentials under Common Services > Device and Credentials > Device Management, then RME will be able to download and archive the configuration from the router.

228
Views
0
Helpful
1
Replies
CreatePlease to create content