Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 2.6 (RME) & SUP1A

When we try to pull a Chassis Slot Detail report out of RME in Ciscoworks for any 6000 series with a SUP1A, it always shows "0".

Other SUP models report the correct information. Compatability issue?

Thank you.

3 REPLIES
Cisco Employee

Re: LMS 2.6 (RME) & SUP1A

What version of code is this switch running?

New Member

Re: LMS 2.6 (RME) & SUP1A

It is various versions of the CatOS 7.6(x) across multiple switches with Sup1A engines.

We have one switch with a Sup2 within the same CatOS 7.6 and it reports fine.

Thank you,

Cisco Employee

Re: LMS 2.6 (RME) & SUP1A

This is most likely due to the entPhysicalVendorType for the chassis slots being zeroDotZero instead of cevContainerSlot. In this case, the slot is ignored by RME inventory, and the total slot count is not properly reflected.

Typically, I would expect this problem to be tied to the software, so I wouldn't expect a Sup2 to work, but you might want to compare the entPhysicalVendorType values from the two switches.

107
Views
0
Helpful
3
Replies