Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

LMS 2.6/Swim: can't upload image D1246T.SPS

Hi,

Customer wants to upload image D1246T.SPS for 2610XM, but it failed I think that image name is not reconize by LMS, is there a way to change image name file as a workaround ?

Thanks, Elisabeth

3 REPLIES
Cisco Employee

Re: LMS 2.6/Swim: can't upload image D1246T.SPS

If it's not an system image (or certain type of modem firmware), then SWIM cannot handle it.  You could, however, use Netconfig to perform a TFTP copy of the file from a network server.  This will be interactive, so be sure to use the interactive notation when defining the job.  For example:

copy tftp://10.1.1.1/D1246T.SPS flash:D1246T.SPS

Or whatever the prompts may be in your case.

New Member

Re: LMS 2.6/Swim: can't upload image D1246T.SPS

Hello Joe,

On the command given:

copy tftp://10.1.1.1/D1246T.SPS flash:D1246T.SPS , I am wondering what does it means the

Richard

Cisco Employee

Re: LMS 2.6/Swim: can't upload image D1246T.SPS

It means, "response to follow."  What comes after is the response to an interactive prompt.

220
Views
0
Helpful
3
Replies
CreatePlease to create content