Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

LMS 2.6 with lot of errors on Netshowserver.log

I am getting lots of errors on the netshowserver.log file. I am attaching a cut from the log file. The error messsages started since the initial lms2.6 installation and still showing after applying all latest updates. Any clue on solving this?

Thanks for any help

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 2.6 with lot of errors on Netshowserver.log

These messages are not errors, and will occur everytime NetShowMgr is restarted. What is happening is that all of the device packages are probed for command sets, then those command sets are added to the database. If the command sets are already in the database, this message is seen. It can be safely ignored.

1 REPLY
Cisco Employee

Re: LMS 2.6 with lot of errors on Netshowserver.log

These messages are not errors, and will occur everytime NetShowMgr is restarted. What is happening is that all of the device packages are probed for command sets, then those command sets are added to the database. If the command sets are already in the database, this message is seen. It can be safely ignored.

98
Views
0
Helpful
1
Replies
CreatePlease to create content