Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 3.0.1 / CM 5.0.2 : 10G links not recognized, a thick line is displayed

Hi,

Does anyone experinced this problem. I have already installed LMS 3.0 and upgraded to Dec Update, but still I encounter same problem. The 10G link connection between devices were not recognized and was seen as a thick black straight line only. I have attached a screenshot for the device.

What would be the problem? thanks.

3 REPLIES
Cisco Employee

Re: LMS 3.0.1 / CM 5.0.2 : 10G links not recognized, a thick lin

If you ran a Data Collection under Campus 5.0, you need to reinitialize your ANI database to complete a fix for a bug that can cause this problem. To reinit the database, run:

NMSROOT/bin/perl NMSROOT/campus/bin/reinitdb.pl

Then run a new Data Collection.

New Member

Re: LMS 3.0.1 / CM 5.0.2 : 10G links not recognized, a thick lin

hi jclarke,

yes. i already did that couple of times but same thing happen.

regads,

Cisco Employee

Re: LMS 3.0.1 / CM 5.0.2 : 10G links not recognized, a thick lin

Then there must be something genuinely wrong with the CDP cache on those devices. Pick two (looks like 10.144.67.37 and 10.144.2.35 would be easiest) and check their "show cdp neighbor" data. This bus link points to an inconsistency in the neighbors on this link (e.g. there is a third neighbor that is not be shown).

100
Views
0
Helpful
3
Replies