The high temperature threshold cannot be changed, but you can modify the relative temperature percentage. You can adjust the temperature percentage under DFM > Configuration > Polling and Thresholds > Managing Thresholds. Click on the Switches and Hubs group, then adjust the relative temperature threshold. Something like 34% should be more in line with what you're looking for.
As for the other event, this is CSCta08882:
For the VSS switch, components are recognized correctly:
1. The sub-modules on the device are listed under the Card section of Detailed Device View. Some of them are obviously incorrect, such as "Chassis 1 CPU of Switching Processor 5" , which should be listed under CPU section. Instead, as Cards, they are given status of NotPresent, and throw alarms for Card OperationallyDown.
2. Non-temperature sensors (such as voltage sensors) are miscategorized as temperature sensors. This results is false temperature out of range alerts.
VSS switch (sysObjectID .18.104.22.168.22.214.171.124.896)
1. To avoid the false alerts, a SNMP view can be used to mask out the Entity MIB entries for the submodules that are mistakenly being listed under Card section.
snmp-server view test entPhysicalEntry.*.1000 include
snmp-server view test entPhysicalEntry.*.2000 include
snmp-server view test entPhysicalEntry exclude
snmp-server view test iso include
However, there is no workaround to the fact that those submodules will not be properly managed/monitored.
Further Problem Description:
The processor component is not discovered from Incharge. Thus the sub-modules of processor components are displayed randomly in Card component of DDV, and have a status of NotPresent, and will generate false alerts.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...