Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

LMS 3.0.1 error: "No buffer space available"

Hi,

we are configuring a LMS 3.0.1. Yesterday everything runs perfectly but this morning it was stopped. We have been looking trough the logs and I have found the messages I attach in the ani.log.

The message "No buffer space available (maximum connections reached?): JVM_Bind" is very strange.

We also are testing HUM module and yesterday we configured some pollings. Is it possible that LMS had stopped due to a high load?

Thanks.

3 REPLIES
Cisco Employee

Re: LMS 3.0.1 error: "No buffer space available"

This is most likely related to a problem with DFM. Upgrade to DFM 3.0.3, reboot, and this problem should go away.

New Member

Re: LMS 3.0.1 error: "No buffer space available"

Thank you very much, I've applied the DFM 3.0.3 patch and now we will wait until tomorrow for testing the results.

I'm not sure if it's related but it was mandatory to set up a SMTP server in the LMS 3.0.1 custom installation and we don't want to use it, how can we delete this SMTP server?

If we uninstall only DFM and IPM modules, LMS will run perfectly or could we cause it any damage?

Thanks.

Cisco Employee

Re: LMS 3.0.1 error: "No buffer space available"

You can remove the SMTP server under Common Services > Server > Admin > System Preferences. RME and Campus will work fine if DFM and IPM are not installed.

211
Views
4
Helpful
3
Replies
CreatePlease to create content