Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

LMS 3.0 CiscoView 6.1.6

I'm unable to view the 2800 series routers via Cisco View. I have installed the device package. I am able to view 2600 series router and 3600 series however any suggestions?

7 REPLIES
Cisco Employee

Re: LMS 3.0 CiscoView 6.1.6

What version of the Rtr2800 package did you load? What is the sysObjectID of the router you're trying to view?

New Member

Re: LMS 3.0 CiscoView 6.1.6

Version 8.0 sysObject ID 1.3.6.1.4.1.9.1.578

Thanks for the help

Cisco Employee

Re: LMS 3.0 CiscoView 6.1.6

Please post the list of directory contents for NMSROOT/MDC/tomcat/webapps/CVng/WEB-INF/classes/com/cisco/nm/cvw/devpkgs and NMSROOT/www/classpath/com/cisco/nm/xms/psu/pkgs/cvw.

New Member

Re: LMS 3.0 CiscoView 6.1.6

Here are the files you asked for.

Cisco Employee

Re: LMS 3.0 CiscoView 6.1.6

You haven't properly loaded the Rtr2800 package. Shutdown dmgtd, then delete the Rtr2800.zip files from both directories. Remove the Rtr2800 directory from the devpkgs directory. Then restart dmgtd.

Then, go to Common Services > Software Center > Device Update, check the box next to CiscoView, and click Check for Updates. Download all of the available CiscoView updates, and choose to install them via the GUI. Once that is complete, you should have working 2800 support in CiscoView.

New Member

Re: LMS 3.0 CiscoView 6.1.6

Jclarke

I have started working on the problem again and it still exist. I have upgraded CV to 6.1.7 but that didn't help either. In CV it looks like it's loading the device and then about half way it freezes.

Cisco Employee

Re: LMS 3.0 CiscoView 6.1.6

This is a different problem. It sounds like there is an SNMP timeout while CV is querying the device. Can you provide a sniffer trace filtering on udp/161 traffic to this device when opening it in CiscoView?

127
Views
0
Helpful
7
Replies
CreatePlease to create content