Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

LMS 3.0: Device Center --> telnet to a non cisco device

Hi folks!

Anybody knows if is it possilbe to launch a telnet to a non cisco device already present in the DCR ??

Thanks a lot!

Leonardo

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 3.0: Device Center --> telnet to a non cisco device

Sure. If the device is in DCR (or even if it isn't), you can launch Device Center for that device, and see the Telnet link under tools. This link is simply the URL telnet://DEVICE where DEVICE is the IP address or hostname specified. Provided your browser is configured to support the telnet: URI, it will work.

1 REPLY
Cisco Employee

Re: LMS 3.0: Device Center --> telnet to a non cisco device

Sure. If the device is in DCR (or even if it isn't), you can launch Device Center for that device, and see the Telnet link under tools. This link is simply the URL telnet://DEVICE where DEVICE is the IP address or hostname specified. Provided your browser is configured to support the telnet: URI, it will work.

123
Views
0
Helpful
1
Replies
CreatePlease to create content