Cisco Support Community
Community Member

LMS 3.0 error with RW string.

I've got a trouble with managing deivces under the CW LMS.

Software discovers devices but don't let me manage.

I'v got this config on routers:

snmp-server community xxxxx RO

snmp-server community yyyyy RW

snmp-server ifindex persist

snmp-server chassis-id router_1812_b

snmp-server host version 2c xxxxx

snmp-server host version 2c yyyyy

I chacked credentials 10 times every thing seems to be fine, as i write above

i see every device but when i want to change config for example in Cisco View error pop up:

Timeout on xxxxxxx

This error could be due to lack of access to the host, inwalid SNMP credentials, or a busy device.

To correct problem, do one of the following:

-verify access to the host

-check the SNMP credentials

-incrase timeout value through the preference options on the chassis view

Anyone, could help me with a tip.

Cisco Employee

Re: LMS 3.0 error with RW string.

You should get a sniffer trace of CiscoView trying to communicate with the device to verify that it is using the correct community string. If it is, then perhaps you do need to increase the timeout in CV.

Cisco Employee

Re: LMS 3.0 error with RW string.

You might want to enable CiscoView debugs to get more details on what is happening with snmp.

Also, increase snmp timeout values.

CiscoView - Admin - Debug options and display log

Select SNMP and Activity tracing and click apply and view trace

Minimize the trace window and perform the operation

After it fails what do you see in the trace window? Any snmp errors?

Community Member

Re: LMS 3.0 error with RW string.

Ok, i did what you asked and i've got this

output (ina file)

but i still don't know what is wrong ?

Community Member

Re: LMS 3.0 error with RW string.


I cleared config on devices and in CW, and I fill it again and now it works :|

thx for help.

CreatePlease to create content