Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

LMS 3.0 : RME DCMA0077: Could not create job.

Hi,

We have LMS 3.0. The configs for all devices are shown as out of sync.When i click on "Sync" it give me the error message "DCMA0077: could not create job. Check dcmaclient.log for more details.

Device discovery and data collection are OK.

Does anyone know why this message occurs?

Thanks and regards

Sonu.

10 REPLIES
Cisco Employee

Re: LMS 3.0 : RME DCMA0077: Could not create job.

Please post the dcmaclient.log.

New Member

Re: LMS 3.0 : RME DCMA0077: Could not create job.

I am attaching the file.

Cisco Employee

Re: LMS 3.0 : RME DCMA0077: Could not create job.

Please post the output of the pdshow command.

New Member

Re: LMS 3.0 : RME DCMA0077: Could not create job.

Attaching pdshow.txt

Cisco Employee

Re: LMS 3.0 : RME DCMA0077: Could not create job.

This output is incomplete, but I can already tell you have some process failures. Please provide the complete pdshow output as well as the output of the command, netstat -a -n -o -b.

New Member

Re: LMS 3.0 : RME DCMA0077: Could not create job.

Hi,

In processess i found out that process CTMJrmServer was shut down. This has started and npw the job can be created successfully. But the sync fails and the logs says

>>>>

Protocol ==> Unknown / Not Applicable

Unable to get results of job execution for device. Retry the job after increasing the job result wait time using the option:Resource Manager Essentials -> Admin -> Config Mgmt -> Archive Mgmt ->Fetch Settings

<<<

In RME --> Administration --> Config mgmt --> Transport settings --> Application Archive mgmt has telnet as the first selected protocol.

Attaching pdshow and netstat as well.

Thanks,

Sonu

Cisco Employee

Re: LMS 3.0 : RME DCMA0077: Could not create job.

You appear to be running into a DFM issue. Do you have .NET 2.0 SP1 or higher installed on this server?

New Member

Re: LMS 3.0 : RME DCMA0077: Could not create job.

The Ciscoworks is installed on a windows 2003 server. There is no .NET 2.0 SP1 or above. There is also DHCP running on this machine.

Regards,

Sonu.

Cisco Employee

Re: LMS 3.0 : RME DCMA0077: Could not create job.

DHCP is not supported. You will need to disable all DHCP interfaces, and give the server at least one static IP address. After doing so, you will need to reboot.

New Member

Re: LMS 3.0 : RME DCMA0077: Could not create job.

Actually i meant that the Ciscoworks server also acts as a DHCP server for clients

764
Views
5
Helpful
10
Replies