Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

LMS 3.01 Data collection issues

Hi,

I recently installed 3.0 and upgraded it to 3.01. I was able to do the device discovery and got 142 devices added in DCR.

when I was trying to do a data collection in campus manager it didnot get started. So I tried including devices from DCR, and out of 142 devices only 66 devices got added and that too are shown as unknown and the remaining devices are unmanaged in CM.

while in RME, I was able to do the config management and inventory collection for all the devices.

is there I need to do anything special for LMS 3.01

Regards

sathappan

1 REPLY
Cisco Employee

Re: LMS 3.01 Data collection issues

Data Collection will use the SNMP credentials configured in DCR just as it has done in LMS 2.x. and 3.0. If Campus is unable to manage the devices in question, you may have an SNMP view applied to your community strings that is blocking critical objects needed by Campus Manager, or you have set your SNMP timeouts and retries too low for Data Collection.

101
Views
5
Helpful
1
Replies
CreatePlease to create content