Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

LMS 3.1 Baseline Template Fails

NEED HELP! :-)

I made a baseline template that basicaly says: If you encounter an interface with a vlan24, apply a port-security mac-address sticky command. TEMPLATE FOLLOWS:

In Conditional Block's SUBMODE:

interface [#.*Ethernet.*#]

CLI Command (of conditional block is):

+ switchport access vlan [#(24)#]

Use the SubMode of above condition (yes)

CLI Command:

+ switchport port-security mac-address sticky

UNFORTUNATELY, THE MESSAGE I GET AFTER THE DIRECT DEPLOY IS:

*** Device Details for cdp-aa-sw-c02-02 ***

Protocol ==> Unknown / Not Applicable

Selected Protocols with order ==> SSH

Execution Result:

CM0150 Deploy Baseline template to PRIMARY config on device failed Cause: CM0070 Copy Config to device failed on cdp-aa-sw-c02-02 Cause: Action: Check device credentials and reachability.

CM0100 Copy PRIMARY Running Config to PRIMARY Startup Config on device not attempted

CM0089 Config archival successful for cdp-aa-sw-c02-02

Do you have a clue what is wrong with this immediate job deployment??? Can you help me fix it so it applies correctly!?

Thanx in advance,

WANimal

1 REPLY
Cisco Employee

Re: LMS 3.1 Baseline Template Fails

Post the job directory for this job. The directory is found under NMSROOT/files/rme/jobs/ArchiveMgmt on Windows and /var/adm/CSCOpx/files/rme/jobs/ArchiveMgmt on Solaris.

197
Views
0
Helpful
1
Replies
CreatePlease to create content