It's not a problem with the Perl script, but an issue with the database engine. We found this same kind of time lag with LMS 3.1 data migration when it came to large databases. No, it is not recommended to disable database validation as that is the way to determine if a database is consistent when backed up. Turning that off may make the backup complete faster, but you would not know if the data backed up could be properly restored.
No, that doesn't make sense since the verification is done on the BACKED UP database (i.e. a new engine is always started). What would make sense is if some other LMS process was taking a lot of CPU and further slowing down the verification process. A restart may have corrected that.
We have problem with scheduled LMS 3.1 backup. It takes more than 12hours to finish. You can see in log that backup is scheduled for 18:00h and it waits untill 22:07 to start doing anything. We can't figure out why is there such a delay. It started to happen after system reported lack of free space on disk. And we feed up the space, but then faced this problem with long duration. Before this problem occured backup used to last for 45 min od 1 hour.
Backup to 'C:/BACKUP' started at: [Mon Apr 11 18:01:26 2011]
Apps file : D:\\PROGRA~1\\CSCOpx\\backup\\manifest\\campus\\properties\\datafiles.txt [Mon Apr 11 22:07:07 2011] Archiving the contents of the following directories into C:\BACKUP\2\campus\filebackup.tar [Mon Apr 11 22:07:07 2011] D:\PROGRA~1\CSCOpx\campus\etc\cwsi\DeviceDiscovery.properties D:\PROGRA~1\CSCOpx\campus\etc\cwsi\ANIServer.properties D:\PROGRA~1\CSCOpx\campus\etc\cwsi\ut.properties D:\PROGRA~1\CSCOpx\campus\etc\cwsi\discoverysnmp.conf D:\PROGRA~1\CSCOpx\campus\etc\cwsi\datacollectionsnmp.conf
Do you have any ideas what went wrong and how to fix it?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.