Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

LMS 3.1: jrm not running in fresh Solaris install

I'm currently testing LMS 3.1 in a Solaris zone.

Problems started when I enabled SSL mode.

Even after a complete uninstall/reinstall, jrm always dies (see attached sanitized logfiles).

The log messages do not make sense for me, so what's the problem here?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: LMS 3.1: jrm not running in fresh Solaris install

This is what I thought. Change the ServiceName to the actual short hostname of the zone (i.e. this appears to be simply "lms"). Restart dmgtd.

6 REPLIES
Cisco Employee

Re: LMS 3.1: jrm not running in fresh Solaris install

Please post your /opt/CSCOpx/lib/classpath/jrmuser.properties file.

New Member

Re: LMS 3.1: jrm not running in fresh Solaris install

#Configure the username to pass for Jobcli and Lockcli

#Sun Sep 07 13:27:52 CEST 2008

Username=admin

ServiceName=JrmServiceManager_lms.hrz.uni-bielefeld.de

Cisco Employee

Re: LMS 3.1: jrm not running in fresh Solaris install

This is what I thought. Change the ServiceName to the actual short hostname of the zone (i.e. this appears to be simply "lms"). Restart dmgtd.

New Member

Re: LMS 3.1: jrm not running in fresh Solaris install

Yep, now it's working fine, thanks.

Nevertheless this raises another question.

Should I better enter the FQDN during installation and fix this file again, or is it better to use the unqualified hostname and fix the certificate configuration later?

Cisco Employee

Re: LMS 3.1: jrm not running in fresh Solaris install

It's best if you can use the short hostname as much as possible. The only variable which should hold the FQDN is PX_FQDN which is found in NMSROOT/lib/classpath/md.properties.

New Member

Re: LMS 3.1: jrm not running in fresh Solaris install

Thanks again. I'll use the bare hostname on the next installation attempt.

Now I'd like to see this a) documented and b) enforced by the setup script.

135
Views
0
Helpful
6
Replies
CreatePlease to create content